Construction of Boundary Wall at Compressor Station AC-0 Sui

This tender invites bids for the construction of a boundary wall at Compressor Station AC-0 located in Sui, Multan, under the supervision of Sui Northern Gas Pipelines Limited (SNGPL). The project falls under the Construction & Civil Works Materials category and requires experienced contractors to undertake dismantling of the existing boundary wall, construction of new brick masonry columns, PCC foundations, installation of angle iron and hot dip G.I razor wire, and laying of tuff pavers. The site is industrial with specific engineering challenges including excavation, compaction, and structural reinforcement to ensure durability and safety. The scope includes dismantling existing structures, reusing bricks for ballast, constructing reinforced brick masonry columns spaced at 10 feet centers, and providing a culvert over an existing fire hydrant line. The work demands compliance with technical specifications, including the use of first-class bricks, cement-sand mortar, and high-strength concrete mixes. The contractor must also relocate and install existing gates with proper finishing and painting. Bidders must hold a valid PEC registration and comply with FBR/ATL requirements for the fiscal year 2025-26. Submission of a Bid Security of PKR 60,000 is mandatory, and bids must remain valid for 90 days. The contractor is advised to ensure all statutory obligations, including professional tax, NTN, and PST certificates, are in place before bidding. The submission deadline is set for 0930 hours on 20th April 2026, with bid opening at 1000 hours the same day at the Compression Department, SNGPL Transmission Office, Piran Ghaib Road, Multan. Bidders must submit sealed envelopes clearly marked with technical and financial bids. The physical address for submission is the same as the opening venue. Pro-Tip: Make sure to carefully review the bid security and performance bond requirements, as failure to comply with these financial guarantees can lead to disqualification. Also, verify the technical specifications and ensure samples of materials are approved by the site engineer before execution to avoid costly rework.