Establishment of Biomechanics Labs at Department of Mechanical and Manufacturing Engineering, Pak-Austria Fachhochschule: Institute of Applied Sciences & Technology (PAF-IAST) Haripur

The Pak-Austria Fachhochschule: Institute of Applied Sciences & Technology (PAF-IAST), Haripur invites sealed bids from interested firms registered with FBR having active taxpayer status for the establishment of Biomechanics Labs at the Department of Mechanical and Manufacturing Engineering. This procurement is aimed at equipping the department with advanced biomechanics laboratory facilities to support research and academic activities. Items being procured: - Biomechanics Lab equipment and instruments as detailed in the tender document The bidder must be a registered manufacturer, distributor, dealer, or supplier in Pakistan with sufficient financial, technical, and human resources to complete the contract within the prescribed time. The tender submission shall be made exclusively through the EPADS (E-Pak Acquisition and Disposal System) portal. Bids must be submitted by 14 September 2026 at 11:00 AM, with electronic bid opening scheduled for the same day at 11:30 AM. Manual bids will not be accepted. Earnest Money amounting to 2% of the bid value must be submitted in the form of a CDR, and the original bid security instrument must be delivered before the bid closing time, or the bid will be disqualified. This tender follows the KPPRA Rule 6 (2)(b) Single Stage, Two Envelope Procedure. Interested bidders are advised to carefully review the detailed terms, conditions, and specifications available on the EPADS portal at https://kp.eprocure.gov.pk. The procurement office is located at Pak-Austria Fachhochschule: Institute of Applied Sciences & Technology (PAF-IAST), Haripur, Khyber Pakhtunkhwa. Bidders should ensure timely submission and compliance with all requirements to avoid disqualification. A practical tip for bidders: Ensure your FBR registration and active taxpayer status are up to date and that your bid security is prepared in the correct format to avoid rejection during the technical evaluation.